The ferroresonant, Scott-T design of the PowerHouse Ferro 100 will significantly reduce electricity costs associated with lift truck charging. Both single and three phase chargers are over 83% efficient and have a power factor greather than 0.95. The inherently stable ferroresonant design maintains DC output within 1% even with up to 10% AC power fluctuations. The Ferro 100 Charger is able to fully recharge a 100% discharged battery to a full state of charge in 8 hours, while the failsafe ferroresonant design protects your batteries from overchargering.

Low Maintenance

Maintenance costs are virtually zero for PowerHouse Ferro 100 Chargers. The only routine maintenance required is an occasional cleaning with low-pressure air to remove dust and dirt accumulation. All of the components are easily accessible from the front of the charger and the chargers all have a low center of gravity for safe handling and stacking. The Ferro 100 chargers are all convection cooled, so no fans are required even when they are stacked. All PowerHouse chargers feature a durable and attractive baked-on epoxy finish and can be safely stacked three high.

Charger Controls Extend Battery Life

The PowerHouse microposser-based dl Plus and dl Super Controllers automatically deliver the precisely timed charges that lead-acid batteries need to operate at peak performance. Built-in safety features virtually eliminate operator errors. Manual or automatic equalize charge patterns minimize grid corrosion, eliminate sulfation and prolong battery life. All PowerHouse Ferro Chargers come with these standard features:

• Automatic start eliminates operator erros
• Flush mounted and sealed controls cannot be fould by dirt or moisture
• Checks for correct battery voltage before charging begins.
• 12-hour override timer protects the battery
• Charging automatically resumes after an AC power interruption.

Features of the PowerHouse dI Plus Controller

• Adjustable start delay from 5 seconds to 7 hours 45 minutes in 15 minute increments.
• Monitors voltage and current changes to determine the ideal length of charge time (dVdT/dIdT)
• Manual or automatic equalize, can be set from every cycle to every 7th cycle.
• Battery refresh cycles keep cells at maximum charge.
• Detects hot batteries and shuts down.
• Pre-wired for the optional automatic watering control.
• Large, bright digital display.

Additional Features of the dI Super Controller

• Programmable start delay by minute or time of day.
• Manually or automatically equalizes by cycle or day of week.
• Self-Diagnostic
• High visibility two-line alphanumeric display.
• No optional external programming device required.
• Charge parameters are easily set from the "plain English" menu.
• Automatically adjusts for daylight savings time.
• Capable of two-way communication with the optional Crown Battery Manager networked battery room management system.

Optional Items for All Ferro 100 Chargers

• Remote control via remote mounting of the charger control boards.
• Special leads available for individual charging situations, including series charging, parellel charging and explosion proof battiers (EX)
• JIC-approved flange-mounted disconnect switch with push-to-test light prevents cabinent opening with power on.
• Wall mounting brackets.
• Battery watering module - a solenoid valve automatically waters the battery at the optimal point during the charge cycle.